Roller servo pin?

Discussion in 'Community Support' started by Terry Mackintosh, Dec 30, 2014.

  1. Hi

    I wrote some code to operate the servo to raise and lower the rollers, all seems working, right up to the call to the servo library, but the servo does not move.

    rollers.h says the servo is on pin 12, but maybe that is wrong?

    Does anyone know?

    Thank you

    Terry
  2. Ariel

    Ariel Staff Member

    AOUT1 = pin 10
    AOUT2 = pin 11
    AOUT3 = pin 12

    I confess I have not been as good about posting resources to the wiki as the rest of the team, but putting up full documentation of the electronics is high on my to do list.
  3. Thanks Ariel, that works, pin 10, as per the assembly docs which indicate the AOUT1 connector.

    The printer side code works good now.
  4. OK, control side code is complete from the servo calibration dialog. I'll create a fork on github and get this into it. Should have already done that...
  5. Trent Waddington

    Trent Waddington Staff Member

    This is now merged. Thanks Terry.
  6. You are welcome.

Share This Page