Assembly/First Print Issue

Discussion in 'Community Support' started by Dave Hylands, Sep 17, 2014.

  1. The assembly instructions say to proceed to the Starter Circuit before assembling the Outer Shell.

    However, I'm pretty sure that you need to install the base at the bottom of the printer (included in the Outer Shell instructions) before you can successfully get your first print to work.
  2. Michael Reed

    Michael Reed Staff Member

    Hey Dave - yes you're right. It was a bit of a last minute decision to make sure you did a test print before closing everything up - I will revise the instructions to place the bottom plate pieces in before performing the test print.

    Thanks for pointing this out to me :)

Share This Page