Recent Content by Adam Pautsch

  1. Adam Pautsch
    Thread

    Damaged Pogo Pins

    We were having some trouble printing, and it turned out that 6 or 7 of the pogo pins on one of the pogo boards were stuck. After a little bit of...
    Thread by: Adam Pautsch, Jan 12, 2016, 0 replies, in forum: Community Support
  2. Adam Pautsch
    Post

    First Prints

    Hi John. I made all the adjustments on the stepper drivers when I built the machine, step 12.58. I made some further adjustments, there's a very fine...
    Post by: Adam Pautsch, Mar 3, 2015 in forum: Cool Prints
  3. Adam Pautsch
    Post

    Leaking ascorbic cartridges? (in sealed bag)

    I'm having a similar problem with my ascorbic cartridge. The bag had some leaked liquid. I cleaned that up and wiped off the cartridge. When I loaded...
    Post by: Adam Pautsch, Mar 3, 2015 in forum: Community Support
  4. Adam Pautsch
    Thread

    RBG LED colors don't match

    When I set up my printer (Batch 002), I noticed that the left and right LED RGB colors didn't match. I used the red 255, green 255, blue 255 command...
    Thread by: Adam Pautsch, Mar 2, 2015, 1 replies, in forum: Community Support
  5. Adam Pautsch
    Post

    First Prints

    My first print turned out ... poorly. Not sure what the issue is, anyone have any suggestions? I did the calibration, adjusted the servo controls,...
    Post by: Adam Pautsch, Feb 5, 2015 in forum: Cool Prints